Installation system series

Step-by-step installation

STEP 1
Open the service door using the key. 

STEP 2
Connect the enclosed 230V mains cable to the connection block on the circuit card (there is an illustration in the Manual). 

a) The cable can draw from the rear or in the lower edge on the front, which is pre-punched for holes. 



 

 

 

b) The brown and blue wires must be connected to the connection block. Connect the blue wire to N and the brown wire to F. 

c) The green-yellow wire must be connected using the earth screw next to the connection block. It is important that the green-yellow wire is attached securely as it is the protective earth and it must always be longer than the other two wires.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request