Step-by-step installation
A dealer trained by Creone should perform the installation. Before you start the installation, make sure there are a power plug and network connection available for both the cabinet and the computer. Key cabinet installationOpen the service door in the key cabinet, install the power cable and network cable and connect the cable from the battery to the circuit card.STEP 1 Power up the cabinet and plug in the network cable. Wait until CODE shows: in the display. (It takes a few minutes before anything can be seen on the display; it then takes a further few minutes for the cabinet to start up). STEP 2 Enter the service menu using the Service Code (1234 from the factory). STEP 3 Enter the service menu using the Service Code (1234 from the factory). STEP 4 Select "Date" and "Time" and check these are set correctly. STEP 5 Exit the Service Menu by pressing "*" or selecting "Exit". STEP 6 Now move on to Installation of KeyWin5, to register the cabinet in the system. |